- To install the antenna on the system:
- Remove the caps from the antenna cable [1].
- Loosen and remove the nut [2].
- Remove the metallic washer [3].
2. Push the blank filler with a screw driver.
3. Insert the antenna cables into the antenna slot on the chassis [1].
4. Replace the metal washers on to the antenna connectors [2].
5. Replace the nuts to secure the antenna connectors to the chassis [3].
6. Affix the retention clip on the chassis as show in the image [1].
7. Route the antenna cable through the retention clip [2].
8. Pull off the insulation on the antenna cable connectors [3].
9. Connect the antenna connectors to the connectors on the WLAN card.
10. Tighten the antenna to the antenna cable connector screws.
